The 'standard plots' for EB052B are as follows:

  eb052b_[pass]-weight.ps               station weight vs. time 
  eb052b_[pass]-auto-[1,2].ps           station autocorrelation vs. freq
  eb052b_[pass]-auto-maser-[source].ps  station autocorrelation vs. freq 
  eb052b_[pass]-cross-[1,2].ps          baseline amp/phs vs. freq
  eb052b_[pass]-cross-maser-[source].ps baseline amp vs. freq
  eb052b_[pass]-ampphase-{2}[a,p].ps    Ef-* baseline amp/phs vs. time,

[pass] is either "cont" or "line".  The auto and cross plots show data 
from scan 1 [1] and 82 [2] (both 3C345).  
The [maser] sets of plots show the maser emission for the three targets [source] 
from scans 102, 104, 106.  

The antenna numbering in these plots is 0-based -- thus one less than the
corresponding antenna numbers in the AIPS FITS file.


(a) WEIGHT plots

  The plots shows the weights for all IFs/pols per station, with each
2s integration plotted as a separate ".".   The IF/pol color-coding for
the continuum plot is:

 IF1/RR = red    IF1/LL = blue      IF2/RR = cyan        IF2/LL = green
 IF3/RR = pink   IF3/LL = med.grey  IF4/RR = brown       IF4/LL = purple
 IF5/RR = teal   IF5/LL = yellow    IF6/RR = steel blue  IF6/LL = lt.grey
 IF7/RR = black  IF7/LL = orange    IF8/RR = lt.green    IF8/LL = lt.purple

The line plot with just 1 subband (IF3 from the continnum set-up) has 
only red (RR) and blue (LL).


(b) AUTOCORRELATION SPECTRA plots

  The plots show data from 2 minutes of the scans listed above.  The IFs 
for a station are plotted side-by-side, with RFI in one IF able to throw 
off the y-axis scale for other IFs.  The polarization color-coding is 
RR=red, LL=blue.  
 The [maser] sets of plots show the maser emission for the three targets [source] 
from scans 102, 104, 106, in a sub-set of the frequency points across the 
1024-point IF (to demonstrate that the proper IF was correlated). 



(c) BASELINE SPECTRA plots 

  The baseline vs. frequency plots show vector-averaged amplitude and phase 
for all baselines for the time ranges as the autocorrelation plots, with amp &
phase going to separate plots using the same baseline lay-out on the page.
The polarization color-coding remains RR=red, LL=blue.  Data from the maser
scan shows just amp vs. freq, over the same sub-set of frequency points 
as in the third autocorrelation plot.


(d) AMP/PHASE(t) plots 

  The baseline vs. time plots show amplitude and phase for non-target scans 
on Ef-*, with amp & phase going to separate plots.  Each 2s integration 
is plotted as a separate ".", with the middle 80% of the band used for 
vector-averaging over frequency.  The plots have the same IF/pol color-coding
as in the weight plots.