EVN User Experiment Pipeline Feedback


Pipeline feedback for experiment ED030B. If you have any comments on this experiment please email the address below.
A detailed description of the pipeline output is available.

Last updated: Fri Mar 4 22:09:02 CET 2011 pidopryhora@jive.nl

General Comments. ( Brief data summary and scan listing )
ED030B had 11 stations, 8 x 16 MHz IF, 2 polarizations, and used 32 frequency points per IF/pol, with 4s integrations. In the pipelining, the target source was treated as a phase-referenced source and not directly fringed. The SOLINT was automatically set at 1.910 min. Wb was used as the reference station. The target source 'IRAS10214' was calibrated using the phase-reference source 'PHCAL'. The other phase reference source was 'PHCAL_CHECK', '4C39.25' was a fringe-finder.

The EVN reliability indicator (ERI) for this experiment was ERI = 0.720 . ERI* = 0.817 . Losses include all of Tr (recording failure), sb0 of Mc (RFI), 5 hrs of Ef (late start due to a software/user error), 7 hrs 10 min of On (strong wind), 1 hr 40 min of Zc.

Plots of the autocorrelations
Comments.
Each scan plotted separately, all stations.

plots of the uncalibrated amplitude and phase against time
Comments.
Full-experiment for Wb-* baselines, no calibration applied. A 2-minute plot-averaging was used.

Plots of the uncalibrated amplitude and phase against frequency channel
Comments.
Scalar averaged Wb-* baselines, each scan plotted separately. No calibration applied yet.

The uncalibrated amplitude and phase of the crosshand correlations against frequency channel (not available)
Comments.

TSYS against time
Comments.
TY1 table, each IF/pol on a separate plot.

Telescope sensitivities from the a priori TSYS and Gain curves (the square of this number gives the antenna noise (SEFD) in Jy - the smaller the better).
Comments.
Gain amplitude from CL2 table.

Fringe-fit phase solutions (including Parallactic Angle correction).
Comments.
FRING_PHAS CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2.

Fringe-fit delay solutions
Comments.
SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot.

Fringe-fit rate solutions
Comments.
SN2 station rate solutions.

Telescope bandpasses
Comments.
Bandpass table 1.

Calibrated amplitude and phase against time (a priori amplitude calibration and fringe-fit solutions applied).
Comments.
Full-experiment for Wb-* baselines, calibrated with CL3. The 2-min plot-averaging still applied.

Calibrated amplitude and phase against frequency channel
Comments.
Wb-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps.

Naturally weighted dirty map (not useful for bright sources) produced before self-cal of:
IRAS10214: pdf , or FITS .
PHCAL: pdf (not available) , or FITS (not available) .
4C39.25: pdf (not available) , or FITS (not available) .
PHCAL_CHECK: pdf (not available) , or FITS (not available) .
Comments.

Uniformly weighted dirty map (not useful for bright sources) produced before self-cal of:
IRAS10214: pdf , or FITS .
PHCAL: pdf (not available) , or FITS (not available) .
4C39.25: pdf (not available) , or FITS (not available) .
PHCAL_CHECK: pdf (not available) , or FITS (not available) .
Comments.

Phase corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
IRAS10214 (not available) .
PHCAL .
4C39.25 .
PHCAL_CHECK .
Comments.
Plots of post-SPLIT tables SN1 for the sources.

Amplitude corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
IRAS10214: pdf (not available) , or text file (not available) , or statistical summary (not available) .
PHCAL: pdf , or text file , or statistical summary .
4C39.25: pdf , or text file , or statistical summary .
PHCAL_CHECK: pdf , or text file , or statistical summary .
Comments.
As above, but for the post-SPLIT table SN2.

Telescope sensitivities (the total AMP gain applied during both a priori and self calibration; the square of this number gives the antenna noise (SEFD) in Jy).
Comments.
CL4 gain-amp.

Residual closure phase (visibility closure phase with model closure phase subtracted) for:
IRAS10214 (not available) .
PHCAL .
4C39.25 .
PHCAL_CHECK .
Comments.
Separate files per (fringed) source, showing closure phase plots for all the triangles (not just Wb-*-*). Only stokes=I shown.

Calibrated visibilities and the source model of:
IRAS10214 (not available) .
PHCAL .
4C39.25 .
PHCAL_CHECK .
Comments.
For each (fringed) source, plots of amp/phase on Wb-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted.

Calibrated visibilities against u,v distance for:
IRAS10214: pdf , or png .
PHCAL: pdf , or png .
4C39.25: pdf , or png .
PHCAL_CHECK: pdf , or png .
Comments.
For each source, a plot of amp vs. |uv| distance.

u,v coverage for:
IRAS10214: pdf , or png .
PHCAL: pdf , or png .
4C39.25: pdf , or png .
PHCAL_CHECK: pdf , or png .
Comments.
For each source, a plot of the u-v coverage.

Crude maps of sources:
IRAS10214: pdf , or FITS .
PHCAL: pdf , or FITS .
4C39.25: pdf , or FITS .
PHCAL_CHECK: pdf , or FITS .
Comments.
For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script.