GENERAL EG052B had 10 stations, 2 2MHz IFs, and 4 polarizations, with 1024 frequency points per IF and 2s integrations. Considerably more information is included in the experiment's cover letter on the standard-plots portion of the EVN Archive. The SOLINT was set to 3 min. Ef was used as the reference stations. /// ERIVAL 1.0 /// ERISTAR 1.0 /// ERICOMM /// POSSM_AUTOCORR Each scan plotted separately, all stations. /// VPLOT_UNCAL Full-experiment for Ef-* baselines, no calibration applied. A 3 minute plot-averaging was used. /// POSSM_UNCAL Scalar averaged Ef-* baselines, each scan plotted separately. No calibration applied yet. /// POSSM_CPOL Scalar averaged Ef-* baselines showing LR, each scan plotted separately. No calibration applied yet. /// TSYS TY1 table, each IF/pol on a separate plot. /// GAIN Gain amplitude from CL2 table. /// FRING_DELAY SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot. The clock jump in Wb can be best seen in IF2 (without the line). For this experiment, one lag corresponds to 1/4 microsecond of delay. /// FRING_RATE SN2 station rate solutions. /// FRING_PHAS CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2. /// BANDPASS Bandpass table 1. 3C345, J1743-0350, and J1751+0939 were used for bandpass calibration. /// VPLOT_CAL Full-experiment for Ef-* baselines, calibrated with CL3. The 3-min plot-averaging still applied. /// POSSM_CAL Ef-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps. /// IMAPN /// IMAPU /// CALIB_PHAS1 Plots of post-SPLIT tables SN1 for the sources that have been individually fringed. /// CALIB_AMP2 As above, but for the post-SPLIT table SN2. /// SENS CL4 gain-amp. /// CLPHS Separate files per source, showing closure phase plots for all the triangles. Only stokes=I shown. /// VPLOT_MODEL For each source, plots of amp/phase on Ef-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted. /// UVCOV For each source, a plot of the u-v coverage. /// UVPLT For each source, a plot of amp vs. |uv| distance. /// ICLN For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script. ///