The 'standard plots' for EG062B are as follows:

  eg062b-weight.ps                 station weight vs. time 
  eg062b-auto-[1,2].ps             station autocorrelation vs. freq
  eg062b-cross-[1,2][a,p].ps       baseline amp/phs vs. freq
  eg062b-ampphase-[a,p][2].ps      Ef-* baseline amp/phs vs. time

The auto and cross plots show data from the scans 2 [1] (1803+784) and 
135 [2] (3C454.3; the last scan Sh was in).  The ampphase plots show 
amp [a] and phase [p], omitting target scans.  There is an additional 
amp(t) and phase(t) plot, as described below.  Scan-number references here 
apply to the Wb schedule that has separate HD160934 & J173831 scans.  
The single-dish stations have a single-scan of HD-MID over such a time range; 
these were split into two scans to match the Wb schedule for the correlation.
There are no target scans in the standard plots, so 1 set of standard plots
suffices to summarize both multiple-phase center measurement sets/FITS files.

The antenna numbering in these plots is 0-based -- thus one less than the
corresponding antenna numbers in the AIPS FITS file.


(a) WEIGHT plots

  The plots shows the weights for all IFs/pols per station, with each
2s integration plotted as a separate ".".   The IF/pol color-coding is:

 IF1/RR = red    IF1/LL = blue      IF2/RR = cyan        IF2/LL = green
 IF3/RR = pink   IF3/LL = med.grey  IF4/RR = brown       IF4/LL = purple
 IF5/RR = teal   IF5/LL = yellow    IF6/RR = steel blue  IF6/LL = lt.grey
 IF7/RR = black  IF7/LL = orange    IF8/RR = lt.green    IF8/LL = lt.purple


(b) AUTOCORRELATION SPECTRA plots

  The plots show data from 1 minute of the scans listed above.  The IFs for
each station are separted by the vertical dashed lines.  Since each station
self-scales, y-axes may not go down to zero.  The polarization color-coding
is RR=red, LL=blue. 


(c) BASELINE SPECTRA plots 

  The baseline vs. frequency plots show vector-averaged amplitude and phase 
for all baselines for same the time ranges as the autocorrelation plots, with
amp & phase going to separate plots using the same baseline lay-out on the 
page.  The polarization color-coding remains RR=red, LL=blue. 


(d) AMP/PHASE(t) plots 

  The baseline vs. time plots show amplitude and phase for non-target scans, 
with amp & phase going to separate plots.  Each 2s integration is plotted
as a separate ".", with the middle 80% of the band used for vector-averaging
over frequency.  The plots use the same IF/pol color-coding as in the 
weight plot.  The amp(t) plot shows only J1746+6226, since including the
fringe-finders threw off the y-axis scale.  The additional amp(t) plot
shows only the fringe-finders, but with integration number rather than UT
along the x-asis.