The 'standard plots' for EG062C are as follows:

  eg062c-weight.ps                 station weight vs. time 
  eg062c-auto-[1-3].ps             station autocorrelation vs. freq
  eg062c-cross-[1-3][a,p].ps       baseline amp/phs vs. freq
  eg062c-ampphase-[a,p][2].ps      Ef-* baseline amp/phs vs. time

The auto and cross plots show data from the scans 2 [1] (1803+784),
135 [2] (3C454.3), and 266 [3] (1803+784).  The ampphase plots show 
amp [a] and phase [p], omitting target scans.  There is an additional 
phase(t) plot, as described below.  There are no target scans in the 
standard plots, so one set of standard plots suffices to summarize 
both of the multiple phase-center measurement sets/FITS files.

The antenna numbering in these plots is 0-based -- thus one less than the
corresponding antenna numbers in the AIPS FITS file.


(a) WEIGHT plots

  The plots shows the weights for all IFs/pols per station, with each
2s integration plotted as a separate ".".   The IF/pol color-coding is:

 IF1/RR = red    IF1/LL = blue      IF2/RR = cyan        IF2/LL = green
 IF3/RR = pink   IF3/LL = med.grey  IF4/RR = brown       IF4/LL = purple
 IF5/RR = teal   IF5/LL = yellow    IF6/RR = steel blue  IF6/LL = lt.grey
 IF7/RR = black  IF7/LL = orange    IF8/RR = lt.green    IF8/LL = lt.purple


(b) AUTOCORRELATION SPECTRA plots

  The plots show data from 1 minute of the scans listed above.  The IFs for
each station are separted by the vertical dashed lines.  Since each station
self-scales, y-axes may not go down to zero.  The polarization color-coding
is RR=red, LL=blue. 


(c) BASELINE SPECTRA plots 

  The baseline vs. frequency plots show vector-averaged amplitude and phase 
for all baselines for same the time ranges as the autocorrelation plots, with
amp & phase going to separate plots using the same baseline lay-out on the 
page.  The polarization color-coding remains RR=red, LL=blue. 


(d) AMP/PHASE(t) plots 

  The baseline vs. time plots show amplitude and phase for non-target scans, 
with amp & phase going to separate plots.  Each 2s integration is plotted
as a separate ".", with the middle 80% of the band used for vector-averaging
over frequency.  The plots use the same IF/pol color-coding as in the 
weight plot.  The amp(t) plot shows only J1746+6226, since including the
fringe-finders threw off the y-axis scale.  The additional phase(t) plot
shows only Stokes=LL results, to avoid masking the pattern for Sv which
had very weak RCP fringes in the C-band session.  The color-coding for this
LCP-only phase(t) plot is:

 IF1/LL = red    IF2/LL = blue      IF3/LL = cyan     IF4/LL = green
 IF5/LL = pink   IF6/LL = med.grey  IF7/LL = brown    IF8/LL = purple