GENERAL L band phase-referencing experiment, observed on 8 June 2007. Data rate was 512 Mbps (8 X 16 MHz subbands, dual polarization, two-bit sampling). '4C39.25' was the fringe finder. 10 stations participated. Tr reported the loss of the first 0.5 hour due to error in writing to disk-pack. Tr also has problems with IF7 & 8 (RR). Ef lost a few scans because of "Sources were below the local horizon" and thunderstorms. /// ERIVAL 0.89 /// ERISTAR 0.94 /// ERICOMM (Jb=1, Nt=1, Mc=1, Tr=0.83, ON=1, Wb=1, Ef=0.63, Ur=1, Sh=1, Cm=1) /// POSSM_AUTOCORR Each scan plotted separately, all stations. /// VPLOT_UNCAL Full-experiment for Ef-* baselines, no calibration applied. /// POSSM_UNCAL Scalar averaged Wb-* baselines, each scan plotted separately. No calibration applied yet. /// POSSM_CPOL Scalar averaged Wb-* baselines for the polarization LR. /// TSYS TY1 table, each IF/pol on a separate plot. /// GAIN Gain amplitude from CL2 table. /// FRING_DELAY SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot. /// FRING_RATE SN2 station rate solutions. /// FRING_PHAS CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2. /// BANDPASS Bandpass table 1. 4C39.25 was used for bandpass calibration. /// VPLOT_CAL Full-experiment for Wb-* baselines, calibrated with CL3. The 2.5-min plot-averaging still applied. /// POSSM_CAL Wb-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps. /// IMAPN /// IMAPU /// CALIB_PHAS1 Plots of post-SPLIT tables SN1 for the sources that have been individually fringed. /// CALIB_AMP2 As above, but for the post-SPLIT table SN2. /// SENS CL4 gain-amp. /// CLPHS Separate files per (fringed) source, showing closure phase plots for all the triangles (not just Wb-*-*). Only stokes=I shown. /// VPLOT_MODEL For each (fringed) source, plots of amp/phase on Wb-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted. /// UVCOV For each source, a plot of the u-v coverage. /// UVPLT For each source, a plot of amp vs. |uv| distance. /// ICLN For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script. ///