GENERAL EP067 observed for 16 hours and had 10 stations;Ef Nt Tr Jb Da On Mc Ur Sh Wb, 16 bands with 8 MHz, dual polarization and 2-bit sampling. 2s integrations were used. In the pipelining, the target sources were treated as phase-referenced sources and not directly fringed. The target sources were WNB1328.3+65, WNB1438.0+37, WNB1408.8+46 and WNB1458.0+49; phase referenced by J1344+6606, J1417+4607, J1440+3820 and J1506+4933 respectively. The SOLINT was set automatically at a representative length of a reference-source scan in a phase-reference cycle. Ef was used as the reference station. /// ERIVAL 0.95 /// ERISTAR 0.95 /// ERICOMM Ef=1, Mc=1, On=1, Jb=1, Tr=1, Da=0.79, Wb=1, Nt=1, Sh=1, Ur=1. /// POSSM_AUTOCORR Each scan plotted separately, all stations. In general fairly stable bandpasses.RFI spikes in Mc and Jb IF 8. /// VPLOT_UNCAL Full-experiment for Ef-* baselines, no calibration applied. /// POSSM_UNCAL Scalar averaged Ef-* baselines, each scan plotted separately. No calibration applied yet. /// POSSM_CPOL Scalar averaged Ef-* baselines for LR, each scan plotted separately. No calibration applied yet. /// TSYS TY1 table, each IF/pol on a separate plot. Some very high Tsys measurements for Jb and Mc IF 7 and 8. /// GAIN Gain amplitude from CL2 table. /// FRING_DELAY SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot. Delays fairly stable. /// FRING_RATE SN2 station rate solutions. /// FRING_PHAS CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2. /// BANDPASS Bandpass table 1. 3C345, 3C286 and OQ208 were used for bandpass calibration. Phases deviate from center at edges of bandpass. /// VPLOT_CAL Full-experiment for Ef-* baselines, calibrated with CL3. /// POSSM_CAL Ef-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps. /// IMAPN Naturually weighted dirty map of the targets. /// IMAPU Uniformly weighted dirty map of the targets. /// CALIB_PHAS1 Plots of post-SPLIT tables SN1 for the sources. /// CALIB_AMP2 As above, but for the post-SPLIT table SN2. /// SENS CL4 gain-amp. /// CLPHS Separate files per (fringed) source, showing closure phase plots for all the triangles (not just Ef-*-*). Only stokes=I shown. /// VPLOT_MODEL For each (fringed) source, plots of amp/phase on Ef-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted. /// UVCOV For each source, a plot of the u-v coverage. /// UVPLT For each source, a plot of amp vs. |uv| distance. /// ICLN For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script. ///