GENERAL EP075E had 10 good stations, 8 16MHz IFs, 4 polarizations, 32 frequency points per IF/pol, and 1s integrations. Considerably more information is included in the experiment's cover letter on the standard-plots portion of the EVN Archive. This pipelining corresponds to the multiple phase-center output target ARP299B. In the pipelining, the target sources were treated as phase-reference targets and were not separately fringe-fit. The SOLINT was set automatically to a value commensurate with a typical reference-source scan (~80s) Ef was used as the reference stations. /// ERIVAL 0.805 /// ERISTAR 0.805 /// ERICOMM The losses include Sv being completely lost and Jb for about a half hour. /// POSSM_AUTOCORR Each scan plotted separately, all stations. /// VPLOT_UNCAL Full-experiment for Ef-* baselines, no calibration applied. A 1.5 minute plot-averaging was used. /// POSSM_UNCAL Scalar averaged Ef-* baselines, each scan plotted separately. No calibration applied yet. /// POSSM_CPOL Scalar averaged Ef-* baselines showing LR, each scan plotted separately. No calibration applied yet. /// TSYS TY1 table, each IF/pol on a separate plot. /// GAIN Gain amplitude from CL2 table. /// FRING_DELAY SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot. Outliers in Ur at the end of the experiment in a couple IFs/pols. /// FRING_RATE SN2 station rate solutions. Outliers in Ur at the end of the experiment in a couple IFs/pols. /// FRING_PHAS CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2. /// BANDPASS Bandpass table 1. 4C39.25 was used for bandpass calibration. /// VPLOT_CAL Full-experiment for Ef-* baselines, calibrated with CL3. The 1.5-min plot-averaging still applied. /// POSSM_CAL Ef-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps. /// IMAPN Naturally-weighted dirty maps of the phase-referenced-to sources. /// IMAPU Uniformly-weighted dirty maps of the phase-referenced-to sources. /// CALIB_PHAS1 Plots of post-SPLIT tables SN1 for the sources that have been individually fringed. /// CALIB_AMP2 As above, but for the post-SPLIT table SN2. /// SENS CL4 gain-amp. /// CLPHS Separate files per (fringed) source, showing closure phase plots for all the triangles. Only stokes=I shown. /// VPLOT_MODEL For each (fringed) source, plots of amp/phase on Ef-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted. /// UVCOV For each source, a plot of the u-v coverage. /// UVPLT For each source, a plot of amp vs. |uv| distance. /// ICLN For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script. ///