The 'standard plots' for EP076D are as follows:

  ep076d.{pass}-weight.ps                station weight vs. time 
  ep076d-auto-[1,2].ps                   station autocorrelation vs. freq
  ep076d-cross-[1,2][a,p].ps             baseline amp/phs vs. freq
  ep076d.{pass}-ampphase-[a,p][2].ps     Ef-* baseline amp/phs vs. time

For the plots vs. time, the {pass} string specifies from which correlation pass
the plot comes:
  reg = "regular" correlation, for targets NGC2623 & IC883
  mcg12 = correlation for MCG+12-02-00 (done with station/source positions to
             match the earlier EP076A/B correlations)
  ngc5256 = multi-phase center correlation for NGC5256A,B,C (target scans not
     plotted in the standard plots, so only 1 plot for these three suffices)
The different correlator passes have different sets of time plots since they
cover different time-ranges.  4C39.25 is included in each pass to serve as 
the bandpass calibrator.  There are variants of the amp(t) and phase(t) plots, 
denoted by the extra "2" and the end of the file-name root, as described below.

The auto and cross plots show data from scans 44 ([1], 4C39.25) and 183
([2], J1332+4722).  Hh was already out of the array for [2].

The antenna numbering in these plots is 0-based -- thus one less than the
corresponding antenna numbers in the AIPS FITS file.


(a) WEIGHT plots

  The plots shows the weights for all IFs/pols per station, with each
1s integration plotted as a separate ".".   The IF/pol color-coding is:

 IF1/RR = red    IF1/LL = blue      IF2/RR = cyan        IF2/LL = green
 IF3/RR = pink   IF3/LL = med.grey  IF4/RR = brown       IF4/LL = purple
 IF5/RR = teal   IF5/LL = yellow    IF6/RR = steel blue  IF6/LL = lt.grey
 IF7/RR = black  IF7/LL = orange    IF8/RR = lt.green    IF8/LL = lt.purple


(b) AUTOCORRELATION SPECTRA plots

  The plots show data from the scans listed above.  The IFs for each station
are separted by the vertical dashed lines.  Since each station self-scales,
y-axes may not go down to zero.  The polarization color-coding is 
RR=red, LL=blue. 


(c) BASELINE SPECTRA plots 

  The baseline vs. frequency plots show vector-averaged amplitude and phase 
for all baselines for same the time ranges as the autocorrelation plots, with
with amp & phase going to separate plots denoted by the 'a' or 'p' following
the scan identifier, using the same baseline lay-out on the page.
IFs per baseline are separated by the dashed vertical lines.
The polarization color-coding remains RR=red, LL=blue. 


(d) AMP/PHASE(t) plots 

  The baseline vs. time plots show amplitude and phase for non-target scans,
with amp & phase going to separate plots, denoted by the 'a' or 'p' following
'ampphase-'.  Each 1s integration is plotted as a separate ".", with the middle 
80% of the band used for vector-averaging over frequency.  The main plots have 
the same IF/pol color-coding as in the weight plots.  There are variants for
the amp(t) plots:
   [a2] - omits 4C39.25 to avoid it dominating the amplitude y-axis scale
        for the phase-reference sources.