The 'standard plots' for EY020B are as follows:

  ey020b-weight.ps                station weight vs. time 
  ey020b-auto-[1-3].ps            station autocorrelation vs. freq
  ey020b-cross-[1-3][a,p].ps      baseline amp/phs vs. freq
  ey020b-ampphase-[a,p].ps        Ef-* baseline amp/phs vs. time

The auto and cross plots show 1 minute of data from scan 2 ([1], 3C345)
scan 118 ([2], J1638+5720), and scan 262 ([3], J1638+5720).  The first
plot doesn't have Tr or Sh, the second came at a time when long baselines
to Bd had low amp, and the third doesn't have Sh (and was the last scan
for Wb and Zc).  The ampphase plots show amp [a] and phase [p] separately
versus time.  All standard plots were made from the "TDF" measurement set,
but since the amp and phase plots don't show any target-scan visibilities,
there is no difference between the two multiple phase-center MSs in this
regard.

The antenna numbering in these plots is 0-based -- thus one less than the
corresponding antenna numbers in the AIPS FITS file.


(a) WEIGHT plots

  The plots shows the weights for all IFs/pols per station, with each
2s integration plotted as a separate ".".   The IF/pol color-coding is:

 IF1/RR = red    IF1/LL = blue      IF2/RR = cyan        IF2/LL = green
 IF3/RR = pink   IF3/LL = med.grey  IF4/RR = brown       IF4/LL = purple
 IF5/RR = teal   IF5/LL = yellow    IF6/RR = steel blue  IF6/LL = lt.grey
 IF7/RR = black  IF7/LL = orange    IF8/RR = lt.green    IF8/LL = lt.purple


(b) AUTOCORRELATION SPECTRA plots

  The plots show data from the scans listed above.  The IFs for each station
are separted by the vertical dashed lines.  Since each station self-scales,
y-axes may not go down to zero.  The polarization color-coding is 
RR=red, LL=blue. 


(c) BASELINE SPECTRA plots 

  The baseline vs. frequency plots show vector-averaged amplitude and phase 
for all baselines for same the time ranges as the autocorrelation plots, with
with amp & phase going to separate plots denoted by the 'a' or 'p' following
the scan identifier, using the same baseline lay-out on the page.
IFs per baseline are separated by the dashed vertical lines.
The polarization color-coding is RR=red, LL=blue.

(d) AMP/PHASE(t) plots 

  The baseline vs. time plots show amplitude and phase for non-target scans,
with amp & phase going to separate plots, denoted by the 'a' or 'p' following
'ampphase-'.  Each 2s integration is plotted as a separate ".", with the
middle 80% of the band used for vector-averaging over frequency.  The plots
use the same IF/pol color-coding as in the weight plots.