# ----------------------------------------------- # required parameters version = 31DEC13 # tmask is a range of steps to be carried out. tmask=1 will run the whole # pipeline. tmask = 4 # if a multiple pass experiment then append the pass number to the experiment # name (e.g. n05c3_1) experiment = ey025 userno = 18032 # prioritised list of reference antennas refant = Ef # list of antennas, baselines to which will be plotted. plotref = Ef bpass = 3C84, DA193 # these must be set if phase referencing. Each source in target list will be # phase calibrated by the corresponding source in phaseref list. #phaseref = J1638+57 #target = SW1644 # defaults to typical scan length on phase calibrator. Must be set if not phase # referencing. solint = 2.0 # ----------------------------------------------- # optional parameters # fits directory defaults to the standard archive # fitsdir = /jop21_2/reynolds/evnpipe/test/fits/ # indir and outdir default to $IN/experiment and $OUT/experiment # indir = /jop21_2/reynolds/evnpipe/test/in/ # outdir = /jop21_2/reynolds/evnpipe/test/out/ # no of iterations of selfcal - defaults to 2 (0 is a valid input, not default) sciter=2 # Try sciter=1; if mapping/selfcal fails for some sources, due to few stations # defaults to all fits files that match experiment # nfits = 0 # defaults to 1 nheads = 1 # glue_pass defaults to 1. This is a list of correlator passes that should be # glued together (see help file for explanation). #glue_pass = 1,2 # freqid should *not* be set unless you have multiple freqids in the dataset. # In that case, select the freqid you want to process. #freqid = 1 # averages default to 0 avg = 0 plotavg = 1.0 fring_snr = 5 # ----------------------------------------------- # advanced optional parameters # defaults to doplot = 1 # doplot = 0 doplot = 1 # defaults to 0 #msgkill = # defaults to all sources ### skip line targets # sources=