The 'standard plots' for GA036 are as follows: ga036-weight.ps station weight vs. time ga036-auto-[1-3].ps station autocorrelation vs. freq ga036-cross-[1-3][a,p].ps baseline amp/phs vs. freq ga036-ampphase-[a,p][2].ps Ef-* & Nl-* baselines amp/phs vs. time There were 2 different output multiple phase-center targets, but the standard plots show visibility data from only the reference source and fringe-finder, so only one set of standard plots is needed. The auto and cross plots show data from scan 43 ([1]), scan 189 ([2]), and scan 343 ([3]), all on J1224+2122. The antenna numbering in these plots is 0-based -- thus one less than the corresponding antenna numbers in the AIPS FITS file. (a) WEIGHT plots The plots shows the weights for all IFs/pols per station, with each 2s integration plotted as a separate ".". The IF/pol color-coding is: IF1/RR = red IF1/LL = blue IF2/RR = cyan IF2/LL = green IF3/RR = pink IF3/LL = med.grey IF4/RR = brown IF4/LL = purple IF5/RR = teal IF5/LL = yellow IF6/RR = steel blue IF6/LL = lt.grey IF7/RR = black IF7/LL = orange IF8/RR = lt.green IF8/LL = lt.purple (b) AUTOCORRELATION SPECTRA plots The plots show data from the scans listed above. The IFs for each station are separated by the vertical dashed lines. Since each station self-scales, y-axes may not go down to zero. The polarization color-coding is RR=red, LL=blue. (c) BASELINE SPECTRA plots The baseline vs. frequency plots show vector-averaged amplitude and phase for all baselines for same the time ranges as the autocorrelation plots, with with amp & phase going to separate plots denoted by the 'a' or 'p' following the scan identifier, using the same baseline lay-out on the page. IFs per baseline are separated by the dashed vertical lines. The polarization color-coding is RR=red, LL=blue, RL=cyan, LR=green. Phase(freq) plots show only parallel-hands for clarity. (d) AMP/PHASE(t) plots The baseline vs. time plots show amplitude and phase for non-target scans, with amp & phase going to separate plots, denoted by the 'a' or 'p' following 'ampphase-'. Each 1s integration is plotted as a separate ".", with the middle 80% of the band used for vector-averaging over frequency. The plots use the same IF/pol color-coding as in the weight plots. There is a second phase(t) plot showing just IF4 (red=RR, blue=LL) to make the phase(t) trace stand out better.