# ----------------------------------------------- # required parameters # tmask is a range of steps to be carried out. tmask=1 will run the whole # pipeline. tmask = 4 # if a multiple pass experiment then append the pass number to the experiment # name (e.g. n05c3_1) experiment = gp046b userno = 2093 # refant is a prioritised list of reference antennas refant = Ef, Wb, Ar, Tr, Nt # plotref is a list of antennas, baselines to which will be plotted. plotref = Ef # bpass is a list of sources for bandpass calibration bpass = J0919+3324 # phaseref and target must be set if phase referencing. Each source in target # list will be phase calibrated by the corresponding source in phaseref list. phaseref = J0911+3349, J0911+3349 target = sn2008d, ngc2770b # solint defaults to typical scan length on phase calibrator. Must be set if # not phase referencing. solint = 2.0 # ----------------------------------------------- # optional parameters # directories default to $IN/, $OUT/, # $PIPEFITS/ #fitsdir = /jop21_2/reynolds/evnpipe/test/fits/ #indir = /jop21_2/reynolds/evnpipe/test/fits/ #outdir = /jop21_2/reynolds/evnpipe/test/out/ # fits_file defaults to EVN archive standard names. Do not give the full path # (the directory will be taken from the fitsdir parameter) #fits_file = myfitsfile # sciter is the no of iterations of selfcal - defaults to 2 (0 is a valid # input, not default) sciter=2 # nfits defaults to all fits files that match experiment #nfits = 0 # glue_pass defaults to 1. This is a list of correlator passes that should be # glued together (see help file for explanation). # glue_pass = 1, 2 # freqid should *not* be set unless you have multiple freqids in the dataset. # In that case, select the freqid you want to process. #freqid = 1 # averages default to 0 # I guess first is in seconds, the other in minutes -ZP # avg = 6.0 plotavg = 1.0 # ----------------------------------------------- # advanced optional parameters # fring_snr defaults to 9 fring_snr = 5 # doplot defaults to 1 # Note that -1 does not turn off plotting, it must be 0! # doplot = 0 # disk is the aips disk to use (defaults to 1) #disk = 1 # msgkill is the level of messages output from aips (defaults to 0) #msgkill = # sources defaults to all sources in the SU table #sources =