EVN User Experiment Pipeline Feedback


Pipeline feedback for experiment ES072P. If you have any comments on this experiment please email the address below.
A detailed description of the pipeline output is available.

Last updated: Tue Jul 26 15:08:10 CEST 2016 blanchard@jive.eu

General Comments. ( Brief data summary and scan listing )
ES072P, C-band VLBI experiment on 2015 October 22. ES072P had 9 good stations, 4 2MHz IFs, 4 polarizations, 2048 frequency points per IF/pol, and 1s integrations. Participating telescopes were Effelsberg, Jodrell Bank (MkII), Westerbork (single dish), Medicina, Noto, Onsala, Torun, Yebes, Sardinia, Irbene. Westerbork had a warm receiver and has been dropped. Irbene has very low power in LCP and so no fringes are found by the pipeline. You might be able to recover something if you're careful. Ef was used as reference.


The EVN reliability indicator (ERI) for this experiment was ERI = 0.797 . ERI* = 0.797 . (Ef=1, Wb=0, Jb=1, Mc=1, O8=1, Nt=0.986, Tr=1, Ys=1, Sr=1,Ir=1) Counting losses: Wb missing, NT missed 6 minutes

Plots of the autocorrelations
Comments.
Each scan plotted separately, all stations. MC shows bad (possibly internal) RFI in LL. Ef, HB, MC, O8, Tr, Ys, Sr, NT IR all see maser in autocorr.

Plots of the uncalibrated amplitude and phase against time
Comments.
Full-experiment for Ef-* baselines, no calibration applied. Note Nt missing ~ 15:30 - 15:36

Plots of the uncalibrated amplitude and phase against frequency channel
Comments.
Scalar averaged Ef-* baselines, each scan plotted separately. No calibration applied yet. Maser is seen on all baselines. IR looks worse than ES072O in LL. Probably nothing there.

The uncalibrated amplitude and phase of the crosshand correlations against frequency channel
Comments.
Scalar averaged Ef-* baselines showing LR, each scan plotted separately. No calibration applied yet. TR appears to have really strong cross pols...

TSYS against time
Comments.
TY1 table, each IF/pol on a separate plot. Note IR does not provide TSYS at this time so nominal values have been used, a flat GC has also been applied.

Telescope sensitivities from the a priori TSYS and Gain curves (the square of this number gives the antenna noise (SEFD) in Jy - the smaller the better).
Comments.
Gain amplitude from CL2 table.

Fringe-fit phase solutions (including Parallactic Angle correction).
Comments.
CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2.

Fringe-fit delay solutions
Comments.
SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot.

Fringe-fit rate solutions
Comments.
SN2 station rate solutions.

Telescope bandpasses
Comments.
Bandpass table 1. J2202+4216 and J1331+3030 were used for bandpass calibration.

Calibrated amplitude and phase against time (a priori amplitude calibration and fringe-fit solutions applied).
Comments.
Full-experiment for Ef-* baselines, calibrated with CL3.

Calibrated amplitude and phase against frequency channel
Comments.
Ef-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps.

Naturally weighted dirty map (not useful for bright sources) produced before self-cal of:
J1331+3030: pdf (not available) , or FITS (not available) .
J2136+0041: pdf (not available) , or FITS (not available) .
J2202+4216: pdf (not available) , or FITS (not available) .
G69.52-0.97: pdf (not available) , or FITS (not available) .
Comments.
Naturally-weighted dirty maps of the phase-referenced-to sources (none here).

Uniformly weighted dirty map (not useful for bright sources) produced before self-cal of:
J1331+3030: pdf (not available) , or FITS (not available) .
J2136+0041: pdf (not available) , or FITS (not available) .
J2202+4216: pdf (not available) , or FITS (not available) .
G69.52-0.97: pdf (not available) , or FITS (not available) .
Comments.
Uniformly-weighted dirty maps of the phase-referenced-to sources (none here).

Phase corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1331+3030 .
J2136+0041 .
J2202+4216 .
G69.52-0.97 .
Comments.
Plots of post-SPLIT tables SN1 for the sources that have been individually fringed.

Amplitude corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1331+3030: pdf , or text file , or statistical summary .
J2136+0041: pdf , or text file , or statistical summary .
J2202+4216: pdf , or text file , or statistical summary .
G69.52-0.97: pdf , or text file , or statistical summary .
Comments.
As above, but for the post-SPLIT table SN2.

Telescope sensitivities (the total AMP gain applied during both a priori and self calibration; the square of this number gives the antenna noise (SEFD) in Jy).
Comments.
CL4 gain-amp.

Residual closure phase (visibility closure phase with model closure phase subtracted) for:
J1331+3030 .
J2136+0041 .
J2202+4216 .
G69.52-0.97 .
Comments.
Separate files per (fringed) source, showing closure phase plots for all the triangles. Only stokes=I shown.

Calibrated visibilities and the source model of:
J1331+3030 .
J2136+0041 .
J2202+4216 .
G69.52-0.97 .
Comments.
For each (fringed) source, plots of amp/phase on Ef-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted.

Calibrated visibilities against u,v distance for:
J1331+3030: pdf , or png .
J2136+0041: pdf , or png .
J2202+4216: pdf , or png .
G69.52-0.97: pdf , or png .
Comments.
For each source, a plot of amp vs. |uv| distance.

u,v coverage for:
J1331+3030: pdf , or png .
J2136+0041: pdf , or png .
J2202+4216: pdf , or png .
G69.52-0.97: pdf , or png .
Comments.
For each source, a plot of the u-v coverage.

Crude maps of sources:
J1331+3030: pdf , or FITS .
J2136+0041: pdf , or FITS .
J2202+4216: pdf , or FITS .
G69.52-0.97: pdf , or FITS .
Comments.
For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script.