EVN User Experiment Pipeline Feedback


Pipeline feedback for experiment GP047. If you have any comments on this experiment please email the address below.
A detailed description of the pipeline output is available.

Last updated: Fri Feb 13 14:31:55 CET 2009 campbell@jive.nl

General Comments. ( Brief data summary and scan listing )
GP047 had 9 stations, 8 16 MHz IFs, two polarizations, and used 16 frequency points per IF/pol, with 2s integrations. Considerably more information is included in the experiment's cover letter on the standard-plots portion of the EVN Archive. In the pipelining, the target source was not fringed. The SOLINT was set automatically at a representative length of a reference-source scan in a phase-reference cycle (60s). Ef was used as the reference station, with Gb as a secondary for the last part of the experiment when Ef had left the array.

The EVN reliability indicator (ERI) for this experiment was ERI = 0.967 . ERI* = 0.967 . The ERI was 0.967, with losses including Nt IF7-8/LCP. The ERI is computed from only the EVN stations (thus not including Gb).

Plots of the autocorrelations
Comments.
Each scan plotted separately, all stations.

plots of the uncalibrated amplitude and phase against time
Comments.
Full-experiment for Ef-* & Gb-* baselines, no calibration applied. A 2 minute plot-averaging was used.

Plots of the uncalibrated amplitude and phase against frequency channel
Comments.
Scalar averaged Ef-* & Gb-* baselines, each scan plotted separately. No calibration applied yet.

The uncalibrated amplitude and phase of the crosshand correlations against frequency channel (not available)
Comments.

TSYS against time
Comments.
TY1 table, each IF/pol on a separate plot. Tsys in LCP channels of Jb much higher than in RCP channels (260-600 vs. 50-60). This is also consistent with the lower amplitudes seen in LCP compared to RCP in the standard plots (clearest in the amp vs. freq plots).

Telescope sensitivities from the a priori TSYS and Gain curves (the square of this number gives the antenna noise (SEFD) in Jy - the smaller the better).
Comments.
Gain amplitude from CL2 table.

Fringe-fit phase solutions (including Parallactic Angle correction).
Comments.
CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2.

Fringe-fit delay solutions
Comments.
SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot. Occasional outliers in Wb and On (IF1L, 5R, 5L).

Fringe-fit rate solutions
Comments.
SN2 station rate solutions. Mc and Tr show a clear tail-off towards the end of the experiment. Outliers in some IF/pols in Jb.

Telescope bandpasses
Comments.
Bandpass table 1. 4C39.25 and J1016+2037 were used for bandpass calibration.

Calibrated amplitude and phase against time (a priori amplitude calibration and fringe-fit solutions applied).
Comments.
Full-experiment for Ef-* & Gb-* baselines, calibrated with CL3. The 2-min plot-averaging still applied.

Calibrated amplitude and phase against frequency channel
Comments.
Ef-* & Gb-* baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps.

Naturally weighted dirty map (not useful for bright sources) produced before self-cal of:
J1016+2037: pdf (not available) , or FITS (not available) .
J1051+2119: pdf (not available) , or FITS (not available) .
J1048+2115: pdf (not available) , or FITS (not available) .
G030329: pdf , or FITS .
4C39.25: pdf (not available) , or FITS (not available) .
Comments.
Naturually weighted dirty map of the target.

Uniformly weighted dirty map (not useful for bright sources) produced before self-cal of:
J1016+2037: pdf (not available) , or FITS (not available) .
J1051+2119: pdf (not available) , or FITS (not available) .
J1048+2115: pdf (not available) , or FITS (not available) .
G030329: pdf , or FITS .
4C39.25: pdf (not available) , or FITS (not available) .
Comments.
Uniformly weighted dirty map of the target.

Phase corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1016+2037 .
J1051+2119 .
J1048+2115 .
G030329 (not available) .
4C39.25 .
Comments.
Plots of post-SPLIT tables SN1 for the sources.

Amplitude corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1016+2037: pdf , or text file , or statistical summary .
J1051+2119: pdf , or text file , or statistical summary .
J1048+2115: pdf , or text file , or statistical summary .
G030329: pdf (not available) , or text file (not available) , or statistical summary (not available) .
4C39.25: pdf , or text file , or statistical summary .
Comments.
As above, but for the post-SPLIT table SN2.

Telescope sensitivities (the total AMP gain applied during both a priori and self calibration; the square of this number gives the antenna noise (SEFD) in Jy).
Comments.
CL4 gain-amp.

Residual closure phase (visibility closure phase with model closure phase subtracted) for:
J1016+2037 .
J1051+2119 .
J1048+2115 .
G030329 (not available) .
4C39.25 .
Comments.
Separate files per (fringed) source, showing closure phase plots for all the triangles (not just Ef-*-* or Gb-*-*). Only stokes=I shown.

Calibrated visibilities and the source model of:
J1016+2037 .
J1051+2119 .
J1048+2115 .
G030329 (not available) .
4C39.25 .
Comments.
For each (fringed) source, plots of amp/phase on Ef-* & Gb-* baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted.

Calibrated visibilities against u,v distance for:
J1016+2037: pdf , or png .
J1051+2119: pdf , or png .
J1048+2115: pdf , or png .
G030329: pdf , or png .
4C39.25: pdf , or png .
Comments.
For each source, a plot of amp vs. |uv| distance.

u,v coverage for:
J1016+2037: pdf , or png .
J1051+2119: pdf , or png .
J1048+2115: pdf , or png .
G030329: pdf , or png .
4C39.25: pdf , or png .
Comments.
For each source, a plot of the u-v coverage.

Crude maps of sources:
J1016+2037: pdf , or FITS .
J1051+2119: pdf , or FITS .
J1048+2115: pdf , or FITS .
G030329: pdf , or FITS .
4C39.25: pdf , or FITS .
Comments.
For each source, a CLEAN map resulting from the automated fringing and self-cal iterations (or phase-referencing) in the pipeline script.