EVN User Experiment Pipeline Feedback


Pipeline feedback for experiment RP029A. If you have any comments on this experiment please email the address below.
A detailed description of the pipeline output is available.

Last updated: Mon Aug 28 13:36:06 CEST 2017 marcote@jive.eu

General Comments. ( Brief data summary and scan listing )
RP029A. C band e-EVN phase-referencing experiment, observed on 26 Aug 2017. The data rate was 2048 Mbps (8 x 32 MHz subbands, dual polarization, two-bit sampling). SSS17A is the target source. J1312-2350, NVSS1, NVSS2, and NVSS3 were observed as check sources. J1303-2405 were used as phase calibrator. J1310+3220 was observed as fringe finder.
8 stations participated.

The EVN reliability indicator (ERI) for this experiment was ERI = . ERI* = .

Plots of the autocorrelations
Comments.
Each scan plotted separately, all stations.

Plots of the uncalibrated amplitude and phase against time
Comments.
Full-experiment for Ef-** baselines, no calibration applied. A 1.5 minute plot-averaging was used.

Plots of the uncalibrated amplitude and phase against frequency channel
Comments.
Scalar averaged Ef-** baselines, each scan plotted separately. No calibration applied yet.

The uncalibrated amplitude and phase of the crosshand correlations against frequency channel
Comments.

TSYS against time
Comments.
TY1 table, each IF/pol on a separate plot.

Telescope sensitivities from the a priori TSYS and Gain curves (the square of this number gives the antenna noise (SEFD) in Jy - the smaller the better).
Comments.
Gain amplitude from CL2 table.

Fringe-fit phase solutions (including Parallactic Angle correction).
Comments.
CL3 station phase solutions -- CL3 = CL2+SN2, thus also includes the initial amplitude/parallactic angle calibration from CL2 and the fringe solutions from SN2.

Fringe-fit delay solutions
Comments.
SN2 station delay solutions for the fringed sources, each IF/pol on a separate plot.

Fringe-fit rate solutions
Comments.
SN2 station rate solutions.

Telescope bandpasses
Comments.
Bandpass table 1. J0958+6533 was used for bandpass calibration.

Calibrated amplitude and phase against time (a priori amplitude calibration and fringe-fit solutions applied).
Comments.
Full-experiment for Ef-** baselines, calibrated with CL3. The 1.5-min plot-averaging still applied.

Calibrated amplitude and phase against frequency channel
Comments.
Ef-** baselines calibrated with CL3 and BP1. The amp and phase plots self-scale, not necessarily going down to 0 in the case of the amps.

Naturally weighted dirty map (not useful for bright sources) produced before self-cal of:
J1310+3220: pdf (not available) , or FITS (not available) .
J1312-2350: pdf , or FITS .
NVSS1: pdf , or FITS .
SSS17A: pdf , or FITS .
NVSS3: pdf , or FITS .
J1303-2405: pdf (not available) , or FITS (not available) .
NVSS2: pdf , or FITS .
Comments.

Uniformly weighted dirty map (not useful for bright sources) produced before self-cal of:
J1310+3220: pdf (not available) , or FITS (not available) .
J1312-2350: pdf , or FITS .
NVSS1: pdf , or FITS .
SSS17A: pdf , or FITS .
NVSS3: pdf , or FITS .
J1303-2405: pdf (not available) , or FITS (not available) .
NVSS2: pdf , or FITS .
Comments.

Phase corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1310+3220 .
J1312-2350 (not available) .
NVSS1 (not available) .
SSS17A (not available) .
NVSS3 (not available) .
J1303-2405 .
NVSS2 (not available) .
Comments.
Plots of post-SPLIT tables SN1 for the sources that have been individually fringed.

Amplitude corrections applied to a priori calibrated and fringe-fitted data by self-calibration.
J1310+3220: pdf , or text file , or statistical summary .
J1312-2350: pdf (not available) , or text file (not available) , or statistical summary (not available) .
NVSS1: pdf (not available) , or text file (not available) , or statistical summary (not available) .
SSS17A: pdf (not available) , or text file (not available) , or statistical summary (not available) .
NVSS3: pdf (not available) , or text file (not available) , or statistical summary (not available) .
J1303-2405: pdf , or text file , or statistical summary .
NVSS2: pdf (not available) , or text file (not available) , or statistical summary (not available) .
Comments.
As above, but for the post-SPLIT table SN2.

Telescope sensitivities (the total AMP gain applied during both a priori and self calibration; the square of this number gives the antenna noise (SEFD) in Jy).
Comments.
CL4 gain-amp.

Residual closure phase (visibility closure phase with model closure phase subtracted) for:
J1310+3220 .
J1312-2350 (not available) .
NVSS1 (not available) .
SSS17A (not available) .
NVSS3 (not available) .
J1303-2405 .
NVSS2 (not available) .
Comments.
Separate files per (fringed) source, showing closure phase plots for all the triangles. Only stokes=I shown.

Calibrated visibilities and the source model of:
J1310+3220 .
J1312-2350 (not available) .
NVSS1 (not available) .
SSS17A (not available) .
NVSS3 (not available) .
J1303-2405 .
NVSS2 (not available) .
Comments.
For each (fringed) source, plots of amp/phase on Ef-** baselines, calibrated with (post-SPLIT) table CL3, with a model-line overplotted.

Calibrated visibilities against u,v distance for:
J1310+3220: pdf , or png .
J1312-2350: pdf , or png .
NVSS1: pdf , or png .
SSS17A: pdf , or png .
NVSS3: pdf , or png .
J1303-2405: pdf , or png .
NVSS2: pdf , or png .
Comments.
For each source, a plot of amp vs. |uv| distance.

u,v coverage for:
J1310+3220: pdf , or png .
J1312-2350: pdf , or png .
NVSS1: pdf , or png .
SSS17A: pdf , or png .
NVSS3: pdf , or png .
J1303-2405: pdf , or png .
NVSS2: pdf , or png .
Comments.
For each source, a plot of the u-v coverage.

Crude maps of sources:
J1310+3220: pdf , or FITS .
J1312-2350: pdf , or FITS .
NVSS1: pdf , or FITS .
SSS17A: pdf , or FITS .
NVSS3: pdf , or FITS .
J1303-2405: pdf , or FITS .
NVSS2: pdf , or FITS .
Comments.
For each source, a CLEAN map resulting from the automated fringing and self-cal iterations in the pipeline script.